Download anajet sprint driver

Getting Started. Using Your Printer. AnaJet mPower. AnaJet Sprint. Do NOT click any button during this time. When the installation of the Administrator has been completed, you will see a new dialog. You can now fill in the appropriate information, including your activation serial number, that is required to activate the software.

Then, the Administrator will open in your browser. Alternatively, if you wish to activate later, close this dialog and proceed with the next steps in the installation.

When the installation of the Administrator is complete, you may install the Library and the design software. Return to the Spark Installer to install these components.

Note that the order is crucial — the Administrator must be installed before the Library. Installing the Library.

The Spark Library installs the products, fonts, and images that come with the software. To Install the Library:. Wait a few moments while the necessary files are extracted. You see a new Installshield wizard window. You see the License Agreement window. You see the Ready to Install the Program window. Wait while the files are installed; when the installation is complete, you will see a new Installshield window. The Installshield wizard will close, and you will now have access to the files in the Library through the Spark Administrator.

The Adobe AIR 3. When this installation is complete, Spark will open. You will need a Phillips screw driver and a Antistatic wrist strap to prevent any static electricity from damaging the circuit boards. This cover will have 7 Phillip screws holding it down. Step 2. Next we need to remove the lid of the printer. Inside the printer you will see the strut the holds the lid open. The strut is held by a small E clip. You will need needle nose pliers or a small knife to remove this piece.

Cleaning Solution and cleaning supplies for the Anajet garment printer. While flushing, watch the ink movement in the ink tubes. The more viscous white ink will take longer to clear from the tubes. When all of the tubes are clear going into the print carriage, run a print purge from EKPrint Studioto to assure all ink is clear from the dampers and print head as well as the tubes. You will then be routed to a page with download and installation instructions. When the software is installed double click the AnaRIP icon to launch the software and then connect the printer to the computer using the provided USB cable.

After the cable is installed place an image into the software by going to File and then Place an image. You will then notice that the Print button at the lower right of the software window will be available, this means that the computer and printer are communicating.